Accusplit Fitness Electronics AE1120M2 User Manual

ACCUSPLIT®  
EAGLE1120M2  
MEMORY PEDOMETER  
OPERATING INSTRUCTIONS  
Congratulations on taking the first step to wellness with your purchase of an ACCUSPLIT  
pedometer. It’s easy to set up your new pedometer. Just follow the steps below, and start walking!  
WEARINGYOUR PEDOMETER  
MODES  
• “D”– “Days Steps”  
Counts steps taken since last RESET.  
• “T”–”Total Steps”  
While gently holding the belt clip open, slide the pedometer  
onto your belt or the top edge of your pants or skirt. It should  
fit snugly and level, above one knee.  
Note: The pedometer should be as vertical as possible.  
Walkers with larger stomachs may find it helpful to wear the  
pedometer farther back on the body, toward one hip.  
To avoid losing or dropping your pedometer, use the included  
leash and clip to fasten the pedometer securely to your  
clothing.  
Keeps track of all steps taken, even after  
Days Steps are reset.  
DAY button  
TOTAL button  
10000.org  
AccuSTEP  
D
A
Y
ST  
T
O
T
A
L
Attaching the Leash: Attach the pedometer to the leash by  
looping the leash around the pedometer belt clip. Next, clasp  
the waistband of your clothing with the attached clip. You can  
also use a safety pin to fasten the leash to your clothing, loop  
the leash through your belt or belt loop, or use a badge holder.  
TL  
ACCUSPLIT  
EAGLE  
1 1 2 0 M 2  
T W 1 5 M G  
First, loop the  
pedometer clip  
RESETTINGYOUR PEDOMETER  
Most people prefer to reset step counts daily.  
Next, loop the metal  
clip, then clasp clothing  
To reset: While displaying Day’s Steps, press and hold DAY  
button for at least three seconds to reset to zero. When  
displaying Total Steps, press TOTAL button for three seconds  
to reset Total and Day’s Steps to zero.  
AUTO MOVEMENT SENSOR  
1. To lter out random movements, the unit remains in standby  
mode until 5 continuous steps are registered. Only then are  
the 5 steps calculated in, and an Active indicator “” appears  
on the upper left of display.  
Or, loop a belt  
or belt loop  
2. When regular walk/run movement stops, after 2 seconds the  
timer pauses and the unit switches to standby status (Active  
indicator “” disappears).  
Or, loop a  
badge holder, then  
put into pocket  
(Badge holder  
not included)  
REPLACING THE BATTERY  
When the display starts to dim or goes blank, it is time to replace  
the battery. Your pedometer uses one Type L1142 (LR43) 1.5  
volt silver oxide battery. To replace:  
VIEWINGYOUR RESULTS  
Once you put on your pedometer, it will automatically begin  
to record your steps. Press the DAY button to view today’s  
step count. Press the TOTAL button to view total steps taken.  
1. Using a jeweler’s screwdriver, loosen small screw on back of  
unit. Remove back of case.  
2. Slide the old battery gently out of its holder. Replace it with a  
new battery. The battery’s positive (+) terminal should be  
FACE UP while you put it into the pedometer.  
3. Gently press front and back of pedometer case back together,  
being sure to line up slots and tabs at top and bottom of unit.  
Eat Right! Walk More! Live Well!  
e ACCUSPLIT Lifetyle  
Email (preferred)  
User  
REGISTER NOW Please return  
your AE1120M2 Registration to  
the Repair Center address in the  
warranty, and we will let you  
know about future products.  
ACCUSPLIT, Inc. • 2290M Ringwood Ave. • San Jose, CA 95131  
800-965-2008 • 925-226-0888 • FAX 925-463-0147 • www.ACCUSPLIT.com • [email protected]  
970-043  
 

Abocom Network Router WR104 User Manual
ACP EP Memory Camera Accessories 60X User Manual
AEG Two Way Radio SE 6861 12 User Manual
AGFA Digital Camera COMPACT 100 User Manual
Agilent Technologies Work Light 8163A User Manual
Agilent Technologies Work Light E1401 90493 User Manual
Alto Shaam Fryer ASF 60G User Manual
Amana Convection Oven AMC7159TAB0 User Manual
AO Smith Water Heater 980 Series User Manual
ATN Binoculars NVM14 PT User Manual