Airlink101 PDAs Smartphones ASW308P User Manual

Ver. 1.0  
Section 2  
Connecting the Switch  
Quick Installation Guide  
8-Port 10/100Mbps Switch with 4-Port PoE  
Model #ASW308P  
Ports 1 - 4: These ports are PoE-enabled ports. Connect any PoE compatible  
device to these ports and the Switch will automatically supply power through these  
ports. If you connect a legacy device that is not PoE compatible, the Switch will  
not deliver power to the legacy device. This feature allows you to freely and safely  
mix legacy and PoE compatible devices on your network. The total power  
resource of the system is 30 watt sharing among the 4 PoE ports (maximum  
power per port is 15.4 watt).  
Package Contents:  
Switch with 4-Port PoE  
PowerAdapter  
Rubber Feet Cushion (4)  
Quick Installation Guide  
Ports 5 - 8: These ports are standard Ethernet ports. Connect any legacy device  
to these ports.  
Section 1  
Power Jack: Plug the supplied Power Adapter to the power jack to power on the  
Switch.  
Introduction  
Thank you for purchasing the 8-Port 10/100Mbps Switch with 4-Port Power over  
Ethernet (PoE).  
PoE delivers power and data through one single Category 5 (Cat-5) Ethernet  
cable, eliminating the need to haveAC power available at every location of the  
end-devices such as WLAN access points, IP telephones, and IP cameras. PoE  
is already widely adopted in the market, saving up to 50% of overall installation  
costs by eliminating the need to install separate electrical wiring and power  
outlets.  
Power  
On: When the Power LED lights, the Switch is receiving power.  
Off: When the Power LED is off, the Switch is not receiving power.  
PoE Status  
Green: A PoE device is connected and the port is supplying power.  
Red: When the PoE port has the following problem:  
PoE power circuit shortage  
The Switch can auto-transform between MDI-II or MDI-X type, so you can connect  
your network devices without worrying about using a standard or crossover  
Ethernet cable.  
Power over PoE’s classification  
Out of PoE voltage range of 44 ~ 57 VDC output  
Off: No PoE device is connected.  
Please follow the instructions in this guide to setup the Switch properly.  
 

Actiontec electronic Network Card 802UI3 User Manual
Addonics Technologies Computer Accessories ADU3ESAM User Manual
Addonics Technologies Computer Drive ADSAIDE44 User Manual
AEG Ventilation Hood DK 1160 User Manual
Air King Vacuum Cleaner CVS 22E User Manual
Alesis Musical Instrument K2661 User Manual
Aluratek Battery Charger AUCS02F User Manual
Ativa Paper Shredder 505SB User Manual
Avital Automobile Alarm Hurricane 2 User Manual
Behringer Oxygen Equipment DW400 User Manual