Eureka Tents Tent Hex Screen House User Manual

Fit the Rafters  
Attach the Fabric to the Frame  
• Slide a rafter section labeled  
"TOP" onto a hub arm.The  
spring clip must engage the  
slot in the hub arm. Repeat  
with the remaining until all  
rafters are secured in place.  
See fig.3.  
• Attach all of the top pole clips first. It may be necessary  
to open the doors and step inside the shelter to reach  
the clips. Then, attach all side clips. See fig.6.  
• Stake down all corner rings and your Screen House is  
ready. See fig.7.  
fig.3  
Assembly Instructions for the Hex Screen House:  
You can usually assemble this screen house alone. However,  
with first time set-up or with windy conditions, you will  
need help.  
fig.6  
Component List:  
1 Screen/Body w/ Hub 1 Tent Bag 1 Pole Bag  
6 Rafters 6 Poles 1 Stake Bag and Stakes  
• Make sure the hub and  
fabric are still aligned.  
fig.7  
Layout the Parts  
• Unpack the tent bag, pole bag and separate all of the  
components. Choose a suitable place and unroll and  
unfold the fabric with the Eureka! label up.  
• Assemble all of the chain-corded poles and rafters. Check  
and make sure that each section is fully seated into the  
next. See fig.2.  
Important: Locate the hub fitting attached to the center of  
the tent roof. Align the hub arms to match the layout of the  
corner pins without twisting the fabric. See fig.1.  
Raise the Frame  
• Insert the corner ring & pin into the bottom section of a pole.  
See fig.4. Then fit the top of the pole into the elbow of its  
coresponding rafter.  
• With a second pole, fit it into the diagonal opposite rafter and  
pin to form and arch. Lift the arch, and working your way  
around the frame, attach the remaining poles to erect a  
free standing unit.  
See fig. 5.  
Take down  
fig.4  
• Zip the door closed.  
• Unstake the screen house.  
• Unclip the fabric from the frame.  
fig.1  
• Remove the corner pins from the ends of the  
poles and remove from the rafters.  
• Remove the rafters from the hub. Collapse  
the sections and store in the pole bag.  
fig.2  
• Fold the fabric into thirds. Place the pole  
bag on the fabric and together, roll them up.  
• Pack all components into the storage bag.  
1.800.572.8822  
fig.5  
REV E 10.09  
 

AEG Two Way Radio SE 6861 12 User Manual
Agri Fab Spreader 45 01872 User Manual
Aico Smoke Alarm Ei169RF User Manual
Allied Telesis Network Card AT iMG616BD User Manual
Aluratek Digital Photo Frame ADMPF114F User Manual
Amana Refrigerator SBD21VE User Manual
American Standard Indoor Furnishings 0211008 User Manual
Asus Network Card K7M User Manual
Audiovox Automobile Alarm APS 596a User Manual
Audiovox Stereo Amplifier PAB 250R User Manual